spacers Fitting access control systems to existing architecture may require installations to suit 13mm square section surface-mount conduits. With the minimum of fuss, these mouldings allow the installer to position ‘second-fix’ and surface-wiring installations for RX1 & RX1K and RX4 reader modules.

cover plates When upgrading or replacing existing card readers, the removal of old systems may sometimes leave a ‘footprint’ in the decoration, or perhaps superficial damage to plaster or the wall substrate. To provide a clean and simple solution and help mask minor cosmetic damage, we can offer a limited* range of cover plates to which the backplate of the reader may be fixed. * M.O.Q., may apply

RX1 cover plates A cover plate suitable for both the RX1 and RX1K.

RX2 cover plates Useful to cover cosmetic damage to wall surfaces when replacing some magnetic stripe card readers.

back boxes Similar to the ‘spacers’, and suitable for the RX1/RX1K and RX4 reader modules - these mouldings are suitable for surface-mount installations using 20mm diameter conduits. The back boxes have sufficient depth to accommodate most cable gland nuts, to ensure good- practice wiring installation..

RX3 cover plates Large footprint cover plate suitable for both the RX3 and RX3K readers.

RX4 cover plates Large footprint cover plate suitable for use as a display mounting or to cover more extensive cosmetic damage to the wall surface.

RX6 cover plates Used simply as a sub-mounting plate to offer side-margins to the profile of the reader module.